Duraseal Superbase Sealer One Gallon

Note* Click inside magnifer to see large image

Description
Specifications
Professional View
Similar Products
Top Coat
Stains

Product details: Duraseal Superbase Sealer One Gallon

DURA SEAL Super Base Sealer is a water borne, fast-drying, crystal clear sealer, specially formulated to provide an outstanding base coat for Dura Seal 1000 Water Based Finishes. DURA SEA Super Base Sealer helps prevent tannin discoloration.

Category

Waterbased

Raise Grain

Medium

Model#, UPC#

Component Type

One Component

Odor

Non-offending

Unit of Measure

Gallon

Lot Size

Sheen

Sealer

Special Handling

None

VOC(g/liter)

VOC

Color

Clear

SKU #

Manufacturer

Duraseal

Calculator
Extras
MSDS
Recommended Use
Technical data
Directions

Recommended for both Oil and Water Top Coats
Non-Ambering Oil-Based Appearance
Recoat in 1 to 2 Hours

Super Base Sealer - MSDS

Duraseal Superbase Sealer is excellent for sealing most interior wood surfaces including floors, doors,cabinets, and furniture.

Technical Data

PRODUCT PROPERTIES:
DRY TIME	1-2 hours before applying finish coats
COVERAGE	Approximately 400-500 sq. ft. per gallon
CLEAN UP	Clean application tools with warm water immediately after use
STORAGE	Store at room temperature. Keep from freezing. If frozen, warm to room temperature and mix thoroughly before use
PHYSICAL PROPERTIES:
RESIN TYPE	Styrene Acrylic
DENSITY (LBS/GAL)	8.65
% SOLIDS	33.0
VISCOSITY - CPS	75.0 cps (max.)
pH	4.0
VOC (g/I)	Less than 250 grams/litre or 2.1 lbs/gal
FLASH POINT	Greater than 200°F - Seta Flash

PRODUCT USE:
SURFACE PREPARATION:

Natural Floors:
Sand according to NOFMA or NWFA recommendations. Finish sanding with 120 or 150 grit screen. Do not use steel wool. Vacuum very thoroughly, then tack with a very lightly water dampened cloth to remove all dust.

Stained Floors:
Sand according to NOFMA or NWFA recommendations. Finish sanding with 100 grit screen (80 grit if white stain is used). Do not use steel wool. Apply stain following manufacturer's application and dry time instructions, spot test for compatibility. Make sure stain is thoroughly cured.

NOTE: If high solids stain is used, before top coating, buff cured stain with a green synthetic pad, then tack with a water dampened cloth for best leveling and adhesion.

APPLICATION:
Make sure material is at room temperature. Invert container several times before each use. A synthetic bar applicator is recommended for even application of product, although a synthetic brush or lambs wool applicator may also be used. Best results are obtained at ambient temperatures between 50°F and 90°F, and at humidities below 80%.

Pour a 4-6" wide line of DURA SEAL Super Base Sealer along the starting wall. Go with the direction of the floor or grain.
Pull the sealer with a clean, moistened applicator toward the other wall with an angled, squeegee motion. As you approach the wall, turn the applicator and pad out excess material parallel to the wet edge. Feather all turns, stopping and starting points.
Allow Sealer to dry 1-2 hours before applying finish coats.