Bona Traffic Waterborne Wood Floor Finish

I am a new customer and do not yet have an account here.

By creating an account you will be able to take advantage of this store by shopping faster, be kept up to date on the status of an order, add products to wishlist and keep track of the orders you have made.

I am a returning customer and already have an account here.

E-Mail Address:
Password:

I am a returning customer and already have an account here.

E-Mail Address:
Password:

Your Name:*
Your E-Mail Address:*

Your Friends Name:*
Friends E-Mail Address:*

Full Name:
Email Address:
Enquiry:

Pros: A really durable, light-reflective yet matte finish that holds up well to foot traffic. Cons: Some scratching has occurred, but it`s not very noticeable unless you look very closely. The Bottom Line: In my home, Bona Traffic has lived up to its promise of durability. Our floors look almost as good today as the day they were finished..

U used in my living-room, I loved the shine!

My finish of choice for most projects. Carlisle Tung Oil is the only brand of tung oil I have found that provides a glossy, hard protective finish similar to a poly without the harmful and stinky outgassing associated with polyeurethane-type finishes. On the first coat, the wood soaks up a lot of tung oil. But on additional coats the product goes much farther. I have also used this product over one coat of boiled linseed oil as a first coat to make the tung oil go farther. This works great, but make sure the linseed oil has plenty of time to dry thoroughly before going back with a coat of tung oil. Lightly sand with 220 or finer and wipe off sanding dust with tack cloth between coats, and after 3-6 coats you\'ll have a deep, lustrous, glossy, hard protective finish that\'s all natural. And if you ever need to touch up or refinish, just lightly sand with a fine grit paper and add a fresh coat of tung oil right over the old tun oil finish--no stripping necessary...

I use this on almost everything I build. I've used it on walnut, cherry, maple, jatoba, alder, pine, birch and red oak: decorative items and furniture. My recipe: Sand the bare wood surfaces with 150 and then 220 grit sandpaper. Wear rubber gloves and apply with 0000 steel wool dipped in the finish. Rub the finish into the wood with the steel wool, let it sit for about three minutes and then wipe off the excess with a lint-free cloth. Repeat at 24-hour intervals for a total of 4-6 coats for a nice gloss. The first couple of coats seal up the wood and subsequent coats build up a hard finish on the surface. Be sure not to wipe *everything* off on the last few coats. The steel wool buffs out any imperfections or dust embedded in the previous coats and the result is a silky finish that is almost sensual to the touch. It\'s especially nice on walnut...